Morning Report for September 9, 1999
Headquarters Daily Report SEPTEMBER 09, 1999 *************************************************************************** REPORT NEGATIVE NO INPUT ATTACHED INPUT RECEIVED RECEIVED HEADQUARTERS X REGION I X REGION II X REGION III X REGION IV X PRIORITY ATTENTION REQUIRED MORNING REPORT - HEADQUARTERS SEP. 09, 1999 Licensee/Facility: Notification: Part 21 Database MR Number: H-99-0082 C&D Technologies Date: 09/09/99 Subject: Part 21 - Safety Related Battery Cell Degradation at Cooper Discussion: VENDOR: C&D Technologies PT21 FILE NO: 99-37-0 DATE OF DOCUMENT: 08/25/99 ACCESSION NUMBER: SOURCE DOCUMENT: EN 36073 REVIEWER: REXB, C. Petrone Preliminary information on the cell degradation was provided in morning report H-99-0071 dated August 12, 1999. This morning report is being revised based on information provided in a Part 21 report from C&D Technologies dated August 25, 1999, and through discussions with vendor representatives. The licensee for the Cooper Nuclear Station has found degradation in several cells in their safety related batteries. The cells were manufactured as commercial grade and subsequently dedicated as safety related components by C&D Power Systems. The initial indication of a problem was a lower than expected voltage on several cells during surveillance testing. An inspection of these cells revealed excessive growth of the positive plates. The growth was such that the positive plates appeared to have made contact with the negative plate support structure at the top of the cells. Abnormal growth was subsequently found in the positive plates of other battery cells. Analysis of the cells by C&D indicated that the positive grid material contained excessive levels of calcium. C&D stated that the high calcium content in the alloy would cause higher than expected growth within the positive grids which, over time, would lead to loss of contact between grid and the positive active material of the plate and lead to reduced capacity, reduced voltage and shedding of material. The first sign of the defect is visible growth within the positive plate. C&D believes that these nonconforming levels were caused by inadequate process controls which were corrected by new quality standards which were implemented in January 1997. The cells are now manufactured as safety grade under 10 CFR 50, Appendix B, rather than being manufactured as commercial grade and later being dedicated for safety applications. The defective cells were all type LCR-25 manufactured from 1995 to 1997 under five specific work order numbers, all of which were installed at Cooper. C&D believes that no other utility had received nonconforming cells. However, they are continuing their review and plan to submit a final evaluation to the NRC and any affected utilities within 30 days. _
Page Last Reviewed/Updated Wednesday, March 24, 2021
Page Last Reviewed/Updated Wednesday, March 24, 2021