Event Notification Report for December 22, 1999
U.S. Nuclear Regulatory Commission
Operations Center
EVENT REPORTS FOR
12/21/1999 - 12/22/1999
EVENT NUMBERS
36533
Power Reactor
Event Number: 36533
Facility: DRESDEN
Region: 3 State: IL
Unit: [] [2] []
RX Type: [1] GE-1,[2] GE-3,[3] GE-3
NRC Notified By: SCOTT BRILEY
HQ OPS Officer: DOUG WEAVER
Region: 3 State: IL
Unit: [] [2] []
RX Type: [1] GE-1,[2] GE-3,[3] GE-3
NRC Notified By: SCOTT BRILEY
HQ OPS Officer: DOUG WEAVER
Notification Date: 12/22/1999
Notification Time: 17:10 [ET]
Event Date: 12/22/1999
Event Time: 13:56 [CST]
Last Update Date: 12/22/1999
Notification Time: 17:10 [ET]
Event Date: 12/22/1999
Event Time: 13:56 [CST]
Last Update Date: 12/22/1999
Emergency Class: NON EMERGENCY
10 CFR Section:
50.72(b)(2)(iii)(B) - POT RHR INOP
10 CFR Section:
50.72(b)(2)(iii)(B) - POT RHR INOP
Person (Organization):
MARK RING (R3)
MARK RING (R3)
| Unit | SCRAM Code | RX Crit | Initial PWR | Initial RX Mode | Current PWR | Current RX Mode |
|---|---|---|---|---|---|---|
| 2 | N | Y | 100 | Power Operation | 100 | Power Operation |
SHUTDOWN COOLING INOPERABLE WHILE IN MODE ONE
The logic for the Shutdown Cooling System would have prevented placing Shutdown Cooling in service. Although Shutdown Cooling is not currently required in mode 1, the logic is required. A component had high resistance which generated a signal like an actual high temperature condition. This condition would have prevented placing Shutdown Cooling in service. The high resistance is believed to have been caused by dirty contacts.
The problem has been corrected, and the components are being retested.
The licensee notified the NRC resident inspector.
The logic for the Shutdown Cooling System would have prevented placing Shutdown Cooling in service. Although Shutdown Cooling is not currently required in mode 1, the logic is required. A component had high resistance which generated a signal like an actual high temperature condition. This condition would have prevented placing Shutdown Cooling in service. The high resistance is believed to have been caused by dirty contacts.
The problem has been corrected, and the components are being retested.
The licensee notified the NRC resident inspector.