Service Providers Licensee Toolkit
This toolkit is designed to help licensees find key information easily.
On this page:
This page includes links to files in non-HTML format. See Plugins, Viewers, and Other Tools for more information.
The NRC's regulations are found in Chapter I of Title 10, "Energy," of the Code of Federal Regulations (CFR). Chapter I is divided into Parts 1 through 199.
Consolidated materials guidance is published in "Consolidated Guidance About Materials Licenses" (NUREG-1556).
- Volume 18, Program-Specific Guidance About Service Provider Licenses
- Volume 19, Guidance for Agreement State Licensees About NRC Form 241 "Report of Proposed Activities in Non-Agreement States, Areas of Exclusive Federal Jurisdiction, or Offshore Waters" and Guidance for NRC Licensees Proposing To Work in Agreement State Jurisdiction (Reciprocity)
Regulatory guides are issued in 10 divisions and are intended to aid licensees in implementing regulations. For a specific list of the most applicable guides in Division 8, Occupational Health, see the Medical, Industrial, and Academic Uses of Nuclear Materials Regulations, Guidance, and Communications page.
Web (HTML) versions of some regulatory guides are available for viewing or downloading at this site. In the index for each division of guides, the number of each guide available at this site is underscored. All active final and draft guides are also available in NRC's Agencywide Documents Access and Management System (ADAMS).
NRC's regional offices (Region I - East, Region III - Midwest, and Region IV - West/Southwest) conduct typically unannounced, periodic inspection of licensed activities using guidance from Inspection Manual, Chapter 2800. The frequency of inspection is based on the hazard of materials used.
NRC assigns five-digit program code number(s) to each license according to the principal activities authorized in the license. NRC uses approximately 100 program codes to classify the activities of thousands of active licenses. The program codes that are assigned to a license may be used to identify the applicable fee categories in the schedules in 10 CFR Part 170 and 10 CFR Part 171. To learn more about program codes and the associated fee and inspection categories, see "Consolidated Guidance About Materials Licenses: Guidance About Administrative Licensing Procedures" (NUREG-1556, Vol. 20), Appendix G: LTS Program Code Descriptions. The table below gives information on the program codes for various types of licenses.
Program Codes Used in Service Providers Licensing and Inspection Programs
|License Type||Program Code|
|Leak Test Service Only||03220|
|Instrument Calibration Services Only – Source Less Than 100 Curies or Equal To 100 Curies||03221|
|Instrument Calibration Services Only – Source Greater Than 100 Curies||03222|
|Other Services – Source Less Than 100 Curies or Equal To 100 Curies||03225|
|Other Services – Source Greater Than 100 Curies||03226|
|Waste Disposal Service Prepackaged Only||03232|
|Waste Disposal Service Incineration||03233|
|Waste Disposal Service Processing and/or Repackaging||03234|
|Waste Treatment Service (other than compaction)||03236|
Service provider license applicants are required to pay a fee to the NRC upon application for a new license and are required to pay an annual license fee to the NRC thereafter. Refer to the applicable fee categories in the schedules in 10 CFR Part 170 and 10 CFR Part 171 for the fees required for each category of license and each type of fee.
The following forms are to be used by all service provider licensees.
- Reciprocity Form 241
- License Application Form 313
- Disposition of Materials Form 314
- NRC Form 3
- NRC Form 4
- NRC Form 5